Attributes

Productgroup ID	2
Weight	0kg
Scope of delivery	Including fastening material for mounting the HQ 5 in conveyor sections ST 5/XH, ST 5/H and in the drive modules AS 5/XH, AS 5/H,Incl. support rollers included in all configurations up to b<sub>L</sub> = 845 mm with p = 130 mm or p = 195 mm, as there are no problems with the conveyor trench,Incl. protective covers for the lifting mechanism and roller section,Incl. cover on passive or active side depending on the selection of parameter OFD and use of support rollers,Incl. guide piece and warning label
Delivery information	Fully assembled
Recommended accessories	Lateral guide cover,For position inquiry workpiece pallet sensor 3842545972
Required accessories	Stop gate VE 5/200, VE 5/D‑300, VE 5/D‑301, VE 5/D‑1000 or VE 5/D-1000-E,2x switch bracket SH 2/U‑H for position inquiry top and bottom,Sensor application matrix
Preferred values	455,650,845,1040
King shaft installation on main section [DSM]	1; 2

• The lift transverse unit is a module for branching transport. It lifts the workpiece pallet and moves it transversely to the original conveying direction via a driven roller section.
• Notice:
  -This lift transverse unit is delivered without section.
  - Note the orientation of the workpiece pallet after branching.
  - When using the interface to SEW, the motor is in the direction of transport before HQ 5.
• Can be used with all WT 5 workpiece pallets
• The transverse transport level is 4.5 mm above the transport level of the longitudinal section
• Protective casing can also be removed in the case of low conveyor heights
• Compressed air connection: 5 ... 6 bar
• Pneumatic push-in fitting: 6 mm
• Drive possible with AB 5
• Notice:
  -This lift transverse unit is delivered without section.
  - Note the orientation of the workpiece pallet after branching.
  - When using the interface to SEW, the motor is in the direction of transport before HQ 5. - Notice:
  -This lift transverse unit is delivered without section.
  - Note the orientation of the workpiece pallet after branching.
  - When using the interface to SEW, the motor is in the direction of transport before HQ 5.

Drive possible with AB 5, Pneumatic push in fitting: 6 mm, The lift transverse unit is a module for branching transport. It lifts the workpiece pallet and moves it transversely to the original conveying direction via a driven roller section., Notice