Conveyor units are available in 2 load classes and 3 different system widths (455, 650, 845 mm) for longitudinal conveyors, as well as a further width for transverse conveyors (1040 mm). All rollers in the conveyor unit are driven by a king shaft in the respective drive unit. The king shaft is located behind a protective cover below the transport level; the workpiece pallet can pass over the king shaft. The conveyor units have a symmetrical design and there is no drive side selection. The rollers are driven by bevel wheels; a friction clutch protects the drive during accumulation operation. Additional versions of the products in this category are available on request from our modification department ([email protected]).